Lexus LS 2018 Navigation Manual

To connect your smartphone to the Lexus LS 2018's Bluetooth system, first ensure that Bluetooth is enabled on your phone. Then, go to the 'Setup' menu on your car's display screen, select 'Bluetooth', and choose 'Add Device'. Follow the prompts to pair your phone with the vehicle.
The recommended tire pressure for the Lexus LS 2018 is typically 35 PSI for both front and rear tires. However, it's best to check the sticker located on the driver's side door jamb for specific information.
To reset the maintenance light on your Lexus LS 2018, turn the ignition switch to the 'ON' position, press the odometer button until the total mileage is displayed, turn the ignition off, then hold the odometer button while turning the ignition back to 'ON'. Hold until the maintenance light resets.
The Lexus LS 2018 typically requires 0W-20 synthetic motor oil. Always refer to your owner's manual for the most accurate information specific to your vehicle.
To replace the key fob battery for a Lexus LS 2018, first remove the mechanical key by pressing the release button. Open the key fob case using a flathead screwdriver, then replace the old battery with a new CR2032 battery. Reassemble the key fob.
If the navigation system on your Lexus LS 2018 isn't working, check for software updates, ensure the GPS signal is not obstructed, and verify that the SD card is properly inserted. If the issue persists, consult your Lexus dealer.
Yes, you can update the infotainment system on your Lexus LS 2018. Check the Lexus website or contact your dealer for available updates and installation instructions.
To change a flat tire on the Lexus LS 2018, first ensure the vehicle is on a level surface. Remove the wheel cover, loosen the lug nuts, jack up the car, remove the lug nuts and the flat tire, then mount the spare tire. Tighten the lug nuts and lower the vehicle.
The Lexus LS 2018 has a towing capacity of approximately 1,600 pounds. It's important to consult your owner's manual to ensure safe towing practices and verify specific towing capabilities.
To set up adaptive cruise control in your Lexus LS 2018, press the 'ON/OFF' button on the steering wheel to activate the system. Use the 'SET' button to set your desired speed, and adjust the following distance using the distance control switch.