Lexus GS 2012 Navigation Manual

To reset the maintenance light, turn the ignition to the "ON" position without starting the engine. Press the "ODO/TRIP" button to display "ODO". Turn the ignition off, press and hold the "ODO/TRIP" button, and turn the ignition back to the "ON" position. Continue holding the button until the maintenance light turns off.
The 2012 Lexus GS Sedan typically requires SAE 5W-30 synthetic motor oil. Always consult your owner's manual for specific recommendations.
To pair your phone, enable Bluetooth on your phone. On the car's multimedia system, go to "Setup" and then "Bluetooth". Select "Add Device" and choose your phone from the list. Follow the prompts to complete pairing.
The recommended tire pressure for the 2012 Lexus GS Sedan is typically 35 psi for both front and rear tires. Always check the placard on the driver's door jamb for exact specifications.
Open the glove box and remove any contents. Detach the damper arm on the side. Squeeze the sides of the glove box to release it from the dashboard. Locate the air filter cover, remove it, and replace the old filter with a new one. Reassemble in reverse order.
Try resetting the system by turning the ignition off and then back on. If the issue persists, check for any software updates or consult a Lexus dealership for further assistance.
Maintain regular service intervals, ensure tires are properly inflated, avoid excessive idling, and drive at steady speeds. Removing unnecessary weight can also help improve fuel efficiency.
The 2012 Lexus GS Sedan may have a sealed transmission, meaning it does not have a traditional dipstick. It's best to have the transmission fluid checked by a professional mechanic.
The 2012 Lexus GS Sedan is typically not recommended for towing. Always refer to the owner's manual for any specific guidelines or consult with a Lexus dealership.
Open the hood and locate the back of the headlight assembly. Remove the protective cover, disconnect the electrical connector, and release the retaining clip. Replace the old bulb with a new one, ensuring not to touch the glass part of the bulb. Reassemble in reverse order.