KitchenAid KRSF705HBS Energy Guide
![KitchenAid KRSF705HBS Refrigerator manual cover](/images/OFytnpFklGYEClYImNmNyKzd/thumbs/thumb175x175.webp)
To change the water filter, locate it in the upper right corner of the refrigerator compartment. Turn the filter counterclockwise to remove it. Insert the new filter and turn it clockwise until it clicks into place. Run water through the dispenser for 5 minutes to flush the system.
Ensure the refrigerator is plugged in and the temperature settings are correct. Check the condenser coils for dust and debris, and clean them if necessary. Verify that the door seals are intact and not obstructed. If issues persist, contact a service technician.
Locate the on/off switch on the ice maker and turn it off for 30 seconds. Then, turn it back on. Ensure the ice maker's bin is properly aligned and that the water supply line is not kinked.
Check if the refrigerator is level and adjust the feet if necessary. Ensure that nothing inside the refrigerator is vibrating against the walls. If the noise persists, it may be an issue with the condenser fan or compressor, and a technician should be consulted.
Remove the shelves and drawers from the refrigerator. Wash them with warm, soapy water, rinse thoroughly, and dry completely before placing them back into the fridge. Avoid using abrasive cleaners that can scratch surfaces.
The recommended temperature setting for the refrigerator is 37°F (3°C) and for the freezer is 0°F (-18°C). Adjust as necessary based on usage and ambient room temperature.
The KitchenAid KRSF705HBS is a frost-free model, so manual defrosting is not necessary. However, if you notice frost buildup, ensure the door seals are intact and that the doors are closing properly.
Keep the refrigerator and freezer full to help maintain temperature stability. Ensure the door seals are clean and tight. Place the refrigerator away from heat sources and direct sunlight. Regularly clean the condenser coils.
Check that the water supply line is connected and the valve is turned on. Ensure the water filter is installed correctly and not clogged. If the problem persists, there may be an issue with the dispenser control board or water inlet valve, requiring professional service.
To enable Sabbath Mode, press and hold the "Sabbath Mode" button for three seconds. This will disable interior lights, sounds, and certain features to comply with Sabbath requirements. Press and hold the button again to exit Sabbath Mode.