JVC RD-D90 Instruction Manual

To pair your Bluetooth device with the JVC RD-D90, first ensure that the sound system is in Bluetooth mode. Then activate Bluetooth on your device and scan for nearby devices. Select "JVC RD-D90" from the list to establish a connection.
First, check that the power cable is securely connected to both the unit and the power outlet. Ensure the outlet is functioning by testing it with another device. If the problem persists, it may require service from a professional technician.
To reset the JVC RD-D90 to factory settings, turn off the unit. Press and hold the "Stop" button on the unit for about 5 seconds until "RESET" appears on the display. Release the button to complete the reset process.
Use a soft, dry cloth to clean the exterior of the JVC RD-D90. Avoid using water or chemical cleaners. For the best results, clean the device regularly to prevent dust build-up.
Yes, the JVC RD-D90 can be operated with the supplied remote control. Ensure the remote has working batteries and is pointed directly at the unit when in use.
Check if the volume is turned up and not muted. Ensure all cables are properly connected. If using Bluetooth, verify that the device is paired and the correct audio source is selected.
Extend the FM antenna fully and adjust its position to improve reception. If the signal is weak, try relocating the unit closer to a window or higher in the room.
The JVC RD-D90 supports USB flash drives up to a maximum of 32GB. Ensure the drive is formatted in FAT32 file system for compatibility.
Press the "Clock/Timer" button on the remote. Use the "Skip" buttons to adjust the hour and press "Set" to confirm. Repeat the process to set minutes and finalize by pressing "Set" again.
Ensure the Bluetooth device is within range and that there are no large obstacles or interference. If the problem continues, try resetting both the sound system and the Bluetooth device.