Hyundai Elantra 2016 Quick Guide
![Hyundai Elantra 2016 Sedan manual cover](/images/XlCtArKIdMjUBRYZXeFTYIJH/thumbs/thumb175x175.webp)
The recommended tire pressure for a Hyundai Elantra 2016 Sedan is typically 33 PSI for both front and rear tires. Always check the owner's manual or the sticker on the driver's side door jamb for precise information.
Hyundai recommends changing the engine oil every 5,000 to 7,500 miles, depending on driving conditions. Check the owner's manual for specific intervals based on your driving habits.
The Hyundai Elantra 2016 Sedan typically uses 5W-20 or 5W-30 synthetic oil. Always refer to the owner's manual for the manufacturer's recommendations.
To reset the maintenance light, turn the ignition to the ON position, press the 'Trip' button until you reach the 'Service Required' screen, then hold down the 'Trip' button until the screen resets.
Common issues with the Hyundai Elantra 2016 Sedan include transmission shifting problems, peeling paint, sensor malfunctions, and electrical issues. Regular maintenance can help prevent some of these problems.
To improve fuel efficiency, ensure regular maintenance, keep tires properly inflated, avoid excessive idling, and drive at moderate speeds. Removing excess weight from the vehicle can also help.
To change a flat tire, first ensure the car is on a flat surface and engage the parking brake. Loosen the lug nuts, jack up the vehicle, remove the lug nuts and tire, then place the spare tire, tighten the lug nuts, and lower the car. Finally, fully tighten the lug nuts.
To pair a smartphone, enable Bluetooth on your phone, press the 'Phone' button on the car's audio system, select 'Add New,' and choose your phone from the list. Confirm the pairing code on both devices to complete the process.
The Hyundai Elantra 2016 Sedan is not designed for towing heavy loads. While it might handle very light towing, it's best to consult the owner's manual and consider a vehicle designed for towing if necessary.
To replace the cabin air filter, open the glove box, remove the damper arm, squeeze the sides inward to drop it down, and remove the filter cover behind it. Take out the old filter and insert a new one, ensuring the airflow direction is correct.