HPI Racing Savage XS SS 107817 Instruction Manual

Begin by running the engine at low speeds for a few tanks of fuel. Gradually increase the speed and power, allowing the engine to heat cycle and parts to wear in correctly. Avoid full throttle until the break-in process is complete.
Check the battery charge and connections, examine the fuel system for blockages, and ensure the glow plug is functioning correctly. If problems persist, consult the troubleshooting section of the manual.
Adjust the suspension settings to a softer setup for better absorption of bumps. Consider using tires suited for rough terrain and adjust the ride height accordingly.
Regularly clean the air filter, check and tighten all screws, inspect the drivetrain for wear, and lubricate moving parts. Additionally, keep the electronics dry and clean.
To adjust the slipper clutch, remove the gear cover and use a wrench to turn the adjustment nut. Tighten for less slip and loosen for more slip. Ensure it is not too tight to avoid damaging the drivetrain.
For optimal performance, use a high-quality LiPo battery with a high discharge rate, ensuring it fits the recommended specifications for voltage and capacity.
Ensure proper airflow to the engine by keeping vents clear. Use a fan or heat sink on the motor and avoid running at full throttle for prolonged periods. Proper gear ratios can also reduce strain on the engine.
Consider upgrading to a more powerful motor or ESC, using higher capacity batteries, and installing lightweight components to reduce overall weight. Adjusting the gear ratio can also enhance speed.
Adjust the steering trim on your transmitter until the wheels are straight. If necessary, adjust the linkages on the steering servo for precise alignment.
Check the transmitter and receiver batteries, ensure both are turned on, and verify they are properly bound. Inspect the antenna for damage and confirm there is no interference from other devices.