Hotpoint HS 18011 UK Quick Guide
![Hotpoint HS 18011 UK Fridge manual cover](/images/YgSMjuVgOkLMMnFMiOIpttUX/thumbs/thumb175x175.webp)
To adjust the temperature, locate the thermostat dial inside the fridge compartment. Turn the dial clockwise to lower the temperature and counterclockwise to increase it. Monitor the temperature with a thermometer for accurate settings.
Check if the fridge is plugged in and the thermostat is set correctly. Ensure the door seals are clean and not damaged. Clear any obstructions from the air vents inside the fridge to allow proper airflow.
The Hotpoint HS 18011 UK fridge is frost-free, so manual defrosting is not required. However, if frost builds up, check the door seals and ensure the unit is not overloaded.
Regularly clean the condenser coils at the back of the fridge. Check and clean the door seals to maintain an airtight fit. Keep the fridge away from heat sources and ensure proper ventilation around the unit.
Unusual noises may be due to the fridge being unlevelled or items vibrating against each other. Ensure the fridge is on a level surface and that items inside are properly arranged to prevent noise.
To change the light bulb, disconnect the fridge from the power supply. Remove the light cover inside the fridge, unscrew the old bulb, and replace it with a new one of the same type and wattage.
Inspect the door seals for dirt or damage. Clean the seals with warm soapy water and ensure they are not cracked. If the door still doesn't close properly, check if the fridge is levelled correctly.
Ensure the temperature setting is not too low. Avoid placing food items too close to the air vents inside the fridge, as this can cause them to freeze.
Remove all food items and shelves. Use a solution of mild soap and warm water to wipe down the interior surfaces. Rinse with a clean damp cloth and dry thoroughly before replacing the shelves and food.
Ensure the fridge door is closed tightly and opened only when necessary. Keep the fridge at least three-quarters full to maintain temperature stability. Regularly clean the condenser coils and ensure proper ventilation around the unit.