Hoover HNC175S-80 User Manual
![Hoover HNC175S-80 manual cover](/images/ccyQqBWzagnYwJLJqPkHvJKx/thumbs/thumb175x175.webp)
To reset the Hoover HNC175S-80 dryer after a power outage, unplug the machine for a few minutes and then plug it back in. This should reset the control board.
Check the lint filter and exhaust vent for blockages. If clear, inspect the heating element and thermostats for damage and replace if necessary.
Remove the condenser unit from the dryer and rinse it under running water to remove lint and debris. Allow it to dry completely before reinstalling.
Ensure the water tank is emptied and the lint filter is clean. Also, check for any error codes on the display panel that might indicate a specific issue.
The lint filter should be cleaned after every drying cycle to ensure optimal performance and safety.
Refer to the user manual for a list of error codes and their meanings. Follow the suggested troubleshooting steps for each specific code.
It is not recommended to dry shoes in the Hoover HNC175S-80 as it can damage both the shoes and the dryer. Consider air drying or using a dedicated shoe rack accessory.
Use the "Anti-Crease" function if available, and remove clothes promptly after the cycle ends to reduce wrinkles.
Some noise is normal, but excessive noise may indicate an issue with the drum rollers or bearings. Inspect these components and replace if necessary.
Regularly clean the lint filter, check and clean the condenser unit, and empty the water tank after each use. Inspect the drum seal and door gasket for wear.