Hoover HMDN 184 DEN User Manual

To change the water filter, locate the filter compartment inside the refrigerator, turn the filter counterclockwise to remove it, and then insert the new filter by turning it clockwise until it locks into place.
Ensure the refrigerator is plugged in and the thermostat is set to the correct temperature. Check the condenser coils for dirt or dust and clean them if necessary. Make sure the door seals are intact and not allowing warm air to enter.
To adjust the shelves, gently lift the shelf and tilt it upwards to remove it from the support brackets. Place the shelf at the desired height and lower it onto the support brackets ensuring it is level and secure.
Check the door seals for any gaps or damage, as this could allow moist air to enter. Ensure items are not blocking the air vents within the freezer. Defrost the freezer by unplugging the unit and leaving the door open until the frost melts.
It is recommended to clean the condenser coils every six months to ensure optimal efficiency and performance of the refrigerator. Use a vacuum or a soft brush to remove dust and debris.
The recommended temperature setting for the refrigerator compartment is 37°F (3°C) and for the freezer compartment, it is 0°F (-18°C). Adjust the thermostat if necessary to maintain these temperatures.
Ensure the refrigerator is level and stable on the floor. Check for any loose components or items inside that could be vibrating. Make sure the refrigerator is not touching the wall or other appliances.
Set the refrigerator to a lower energy setting or vacation mode if available. Remove perishable items and ensure the doors are securely closed. If leaving for an extended period, consider emptying and unplugging the unit.
After a power outage, the refrigerator should automatically restart. If it does not, unplug the unit for a few minutes and then plug it back in. Check the temperature settings and adjust if necessary.
Check the drain hole for blockages and clear any debris. Ensure that food items are not blocking the airflow inside the unit. Verify the door seals are intact to prevent warm air from entering.