Hoover HDPN 4S622PW-80 User Manual
![Hoover HDPN 4S622PW-80 manual cover](/images/bJjvFdVfYukcyhQySQqLIGrz/thumbs/thumb175x175.webp)
To start a wash cycle, first ensure the dishwasher is loaded correctly and filled with detergent. Close the door, select the desired wash program using the control panel, and press the start button.
Check if the drain hose is kinked or clogged. Clear any obstructions. Additionally, inspect the filter and pump for debris and clean them if necessary.
Remove the lower rack to access the filter. Turn the filter counterclockwise and lift it out. Rinse it under running water to remove debris. Reinstall by aligning it and turning clockwise.
Spots may be due to hard water. Ensure you are using a rinse aid and that it is filled. Also, check the detergent type and amount used.
E3 indicates a heating issue. Check the water heater and thermostat. If the problem persists, contact Hoover customer service for further assistance.
Refer to the user manual for instructions on adjusting water hardness settings via the control panel. This may involve pressing a combination of buttons to enter the settings menu.
Regular maintenance includes cleaning the filter, checking and cleaning spray arms, and wiping down the door seal to prevent mold and odors.
Ensure the spray arms are not blocked or clogged. Check that the dishes are loaded correctly and not obstructing the spray arms. Verify that the correct wash cycle and detergent are being used.
Yes, but ensure the plastic items are labeled as dishwasher safe and place them on the top rack to avoid contact with the heating element.
To reset the dishwasher, turn it off and unplug it from the power source for a few minutes. Plug it back in and turn it on. This should reset the electronic controls.