Hoover HDPN 2D520PB-80 User Manual
![Hoover HDPN 2D520PB-80 manual cover](/images/acoCivaMdhwfUZhlbMyMYwXa/thumbs/thumb175x175.webp)
To reset the Hoover HDPN 2D520PB-80, press and hold the start button for approximately 3 seconds until the control panel lights flash. This will reset the machine.
Check the drain hose for blockages, ensure the sink's drain is clear, and clean the dishwasher's filter. If the problem persists, inspect the pump for any obstructions.
Remove the lower dish rack, twist and lift out the cylindrical filter, rinse it under running water, and use a soft brush to remove debris. Reassemble by aligning and twisting the filter back into place.
Error code E3 on the Hoover HDPN 2D520PB-80 usually indicates a heating issue. Check the heating element and thermostat, and ensure there are no electrical connection issues.
Use a rinse aid to enhance drying, ensure that the dishwasher is loaded correctly with sufficient space between dishes, and select a drying cycle with a higher temperature setting.
Regularly clean the filter, check and clean the spray arms, inspect the door gasket for debris, and run an empty cycle with a dishwasher cleaner monthly to maintain performance.
Unusual noises may be caused by loose items in the dishwasher, a blocked spray arm, or items touching the interior walls. Ensure dishes are loaded correctly and check for any obstructions.
Consult the user manual to find the water hardness adjustment setting in the control panel. Adjust according to your local water hardness level to optimize cleaning performance.
Ensure the door is properly closed and latched, check that the dishwasher is plugged in, and verify that the circuit breaker has not tripped. Also, ensure the delay start option is not activated.
Clean the filter regularly, scrape off food residues before loading, use a dishwasher cleaner monthly, and leave the door slightly open after cycles to allow air circulation.