Hoover HDPN 1L360PA-EGY User Manual
![Hoover HDPN 1L360PA-EGY manual cover](/images/ljuOFeHYSxKoNaoSqdtuJxMU/thumbs/thumb175x175.webp)
Ensure that dishes are not overlapping and that water can reach all surfaces. Place larger items like pots and pans on the sides or in the back, and make sure nothing blocks the spray arms.
Check if the dishwasher is properly plugged in and that the door is fully closed. Ensure that the water supply is turned on and verify that the circuit breaker has not tripped.
Remove the filter from the bottom of the dishwasher and rinse it under running water. Use a soft brush to remove any debris. Reinstall the filter securely before using the dishwasher again.
It is recommended to clean the spray arms every 1-2 months. Remove them and rinse them under water, using a toothpick to clear any blocked holes.
Check for any blockages in the drain hose or filter. Make sure the sink drain is not clogged. If the problem persists, inspect the pump for any obstructions.
To reset the dishwasher, turn it off and unplug it from the power source. Wait 5 minutes, then plug it back in and turn it on. If the error persists, consult the user manual for specific error code solutions.
No, regular dish soap can cause excessive suds and damage the dishwasher. Use only dishwasher-specific detergents as recommended by the manufacturer.
Open the rinse aid dispenser and turn the dial to adjust the setting. Refer to the user manual for guidance on the optimal level for your water hardness.
Ensure that the rinse aid dispenser is filled and consider increasing the rinse aid dosage. Check that you are using the appropriate detergent and that the water temperature is at least 120°F (49°C).
Ensure that the dishwasher is level and that there are no loose items inside. Check that all installation screws are tight and that the dishwasher is not in contact with cabinets or walls.