Ford Fiesta 2019 Owner's Manual

To reset the oil change light on a Ford Fiesta 2019, turn the ignition to the "ON" position without starting the engine. Press and hold both the accelerator and brake pedals for about 25 seconds. The oil change light will flash and then turn off, indicating that it has been reset.
The recommended tire pressure for a Ford Fiesta 2019 is typically 32 psi for both the front and rear tires. Always refer to the sticker located on the driver's side door jamb for the most accurate information.
To pair your phone with the Ford SYNC system in a 2019 Fiesta, ensure Bluetooth is enabled on your phone. On the SYNC screen, select "Phone" > "Add a Device". SYNC will search for your phone. Select your phone from the list and enter the PIN shown on the SYNC screen if prompted.
Ford recommends using SAE 5W-20 engine oil that meets the Ford specification WSS-M2C945-A for the 2019 Fiesta. Always check the owner's manual for the most accurate information.
To replace the cabin air filter in a Ford Fiesta 2019, open the glove box and remove the limiting stop arm. Press the sides of the glove box to release it. Locate the cabin air filter cover, remove it, and replace the filter. Reassemble the glove box components.
If your Ford Fiesta 2019 won't start, first check the battery connections and ensure they are clean and tight. Verify that the battery is charged. If the problem persists, check the starter and ignition system or consult a professional mechanic.
To check the transmission fluid level in a Ford Fiesta 2019, the vehicle should be on a level surface and the engine warmed up. Locate the transmission dipstick, remove it, wipe it clean, then reinsert it fully and remove to check the fluid level. It should be between the "Full" and "Add" marks.
Common issues with the Ford Fiesta 2019's infotainment system include Bluetooth connectivity problems, unresponsive touchscreens, and software glitches. Performing a system reset or updating the SYNC software can often resolve these issues.
Ford generally recommends replacing the timing belt every 60,000 to 100,000 miles, but it's best to consult the owner's manual or a dealership for specific recommendations tailored to your vehicle's engine type.
To jump-start a Ford Fiesta 2019, position the vehicles close enough for cables to reach both batteries. Connect the positive cable to the positive terminal of the dead battery, then to the positive terminal of the good battery. Connect the negative cable to the negative terminal of the good battery, then to an unpainted metal surface on the dead car's engine block. Start the assisting vehicle, then the Fiesta.