Ford F-Series F-53 Commercial Stripped 2019 Owner's Manual

The recommended maintenance schedule includes regular oil changes every 7,500 miles or six months, tire rotations every 10,000 miles, and a thorough inspection of the brake system every 20,000 miles. Refer to the owner's manual for a detailed schedule.
Check the battery connections for corrosion, ensure the fuel system is delivering fuel, and verify that the starter motor and ignition system are functioning properly. If the problem persists, consult a certified mechanic.
The recommended tire pressure for the front tires is 80 psi, and for the rear tires, it is 75 psi. Always refer to the placard located on the driver's side door jamb for specific information.
Turn the ignition to the "ON" position without starting the engine. Press the brake and accelerator pedals simultaneously and hold them down for 25 seconds until the oil change light resets.
The recommended engine oil for the Ford F-53 2019 model is SAE 5W-20, which meets Ford specification WSS-M2C945-A. Always use high-quality oil to ensure optimal engine performance.
To improve fuel efficiency, maintain proper tire pressure, perform regular engine maintenance, avoid excessive idling, and drive at steady speeds. Minimizing cargo weight can also help improve mileage.
The towing capacity of the 2019 Ford F-53 Chassis is approximately 26,000 pounds, depending on the specific configuration and equipment. Verify with your vehicle's manual for precise details.
Start the engine and allow it to reach normal operating temperature. Shift through all gears, then place in park. Remove the transmission dipstick, wipe it clean, reinsert it, and then remove again to check the level against the marked indicators.
A spongy brake pedal could indicate air in the brake lines or a problem with the brake fluid. Inspect for leaks and ensure the brake fluid is at the correct level. Bleeding the brakes may be necessary to remove air trapped in the system.
The fuse box in the 2019 Ford F-53 is located under the dashboard on the driver's side. To access it, remove the panel by pulling it towards you. Refer to the fuse box diagram to locate specific fuses.