Ford F-250 Super Duty 2002 Owner's Manual
![Ford F-250 Super Duty 2002 manual cover](/images/hteVHHCAXzasxzyayteuntvG/thumbs/thumb175x175.webp)
To change the oil, first warm up the engine. Then, turn off the vehicle and place a drain pan under the oil pan. Remove the drain plug and let the old oil drain out completely. Replace the drain plug and remove the old oil filter. Install a new oil filter and fill the engine with the recommended oil type and quantity.
The recommended tire pressure for the 2002 Ford F-250 Super Duty is typically 65 psi for the front tires and 80 psi for the rear tires. However, it's crucial to verify this information from the placard located on the driver's side door jamb or the owner's manual.
If the ABS light is on, it may indicate an issue with the ABS system, such as a faulty sensor or wiring problem. Start by checking the ABS fuse and sensors located at each wheel. If no visible issues are found, use an OBD-II scanner to retrieve error codes that can help diagnose the problem.
The towing capacity of the 2002 Ford F-250 Super Duty varies based on the engine and configuration but generally ranges from 12,500 to 14,500 pounds. Always refer to the owner's manual for specific details regarding your vehicle's towing capabilities.
To replace the brake pads, first lift the vehicle and remove the wheel. Unbolt the caliper and slide it off the rotor. Remove the old brake pads and replace them with new ones. Reinstall the caliper, ensuring it is properly aligned, and then replace the wheel. Make sure to test the brakes before driving.
The 2002 Ford F-250 Super Duty typically uses a Motorcraft Premium Gold Engine Coolant, which is a yellow-colored, ethylene glycol-based antifreeze/coolant. Always check the owner's manual for confirmation and use the correct mixture of coolant and distilled water.
To improve fuel economy, ensure regular maintenance such as timely oil changes, maintaining proper tire pressure, and using the recommended grade of motor oil. Additionally, reduce excess weight, drive at steady speeds, and avoid excessive idling.
To reset the check engine light, first resolve the underlying issue causing the light to illuminate. Once fixed, use an OBD-II scanner to clear the error codes. If a scanner is unavailable, disconnect the battery for a few minutes, then reconnect it to reset the light.
The correct spark plug gap for the 2002 Ford F-250 Super Duty is generally 0.044 inches. Always refer to the owner's manual or the specifications label under the hood for the most accurate information.
To inspect the serpentine belt, look for signs of wear such as fraying, cracks, or glazing. To replace it, locate the tensioner pulley and use a wrench to rotate it, releasing tension on the belt. Slip the belt off the pulleys, then install the new belt following the belt routing diagram. Ensure proper tension and alignment before starting the engine.