Ford Expedition 2002 Owner's Manual
![Ford Expedition 2002 manual cover](/images/JnmlcNyYVogEGnzkkiQXRoqH/thumbs/thumb175x175.webp)
To replace the rear brake pads on a 2002 Ford Expedition, first, loosen the lug nuts and lift the vehicle using a jack. Remove the tire to access the brake caliper. Unbolt the caliper and slide it off the rotor. Remove the old brake pads and install the new ones, ensuring they are properly seated. Reattach the caliper, put the tire back on, and lower the vehicle.
The 2002 Ford Expedition typically requires 5W-20 motor oil. It's recommended to use a high-quality synthetic or conventional oil that meets the API certification for best performance.
To troubleshoot overheating, check the coolant level and ensure there are no leaks. Inspect the radiator for clogs or damage, and verify that the radiator fan is operational. Also, examine the thermostat and water pump for proper function.
The recommended tire pressure for a 2002 Ford Expedition is typically 35 PSI for both front and rear tires. Always refer to the owner's manual or the sticker located on the driver's door jamb for the most accurate information.
To reset the check engine light on a 2002 Ford Expedition, use an OBD-II scanner to read and clear the codes. Alternatively, disconnect the battery for about 15 minutes, then reconnect it. Note that this may cause loss of radio presets and other memory settings.
To improve fuel efficiency, ensure regular maintenance such as timely oil changes, air filter replacements, and tire pressure checks. Drive at steady speeds, avoid rapid acceleration, and reduce excess weight in the vehicle.
Common electrical issues include battery drain, faulty alternators, and malfunctioning power windows. To resolve, check battery connections, test the alternator output, and inspect fuses and wiring for damage.
To replace the air filter, locate the air filter housing under the hood. Unclip or unscrew the housing cover and remove the old filter. Insert the new air filter, ensuring it fits snugly, and reattach the cover securely.
Starting problems can be caused by a weak battery, faulty starter motor, or ignition switch issues. Check the battery voltage, inspect the starter for wear, and ensure the ignition switch is functioning properly.
To change the transmission fluid, lift the vehicle and secure it on jack stands. Remove the transmission pan bolts, drain the old fluid, and replace the filter if applicable. Reattach the pan with a new gasket and refill the transmission with the appropriate fluid type.