Fender Mustang GT40 2310100000 120V US Manual Addendum

To connect the Fender Mustang GT40 to your computer, use a USB cable to link the amp's USB port to your computer. Once connected, the amp should be recognized as an audio interface, allowing you to record directly into your DAW software.
Check the power cable and ensure it's securely plugged into both the amplifier and a working power outlet. Verify that the power switch is turned on. If it still doesn't turn on, try using a different power cable. If the issue persists, contact Fender support for further assistance.
Download the Fender Tone app on your smartphone or tablet. Connect your device to the amplifier via Bluetooth. Open the app, go to the settings menu, and check for firmware updates. Follow the on-screen instructions to complete the update process.
Use a soft, dry cloth to wipe down the exterior surfaces of the amplifier. Avoid using any liquid cleaners or solvents. Regularly check and clean the input jacks and knobs to ensure optimal performance. Store the amplifier in a dry environment to prevent moisture damage.
To reset the Mustang GT40 to factory settings, press and hold the 'Encoder' and 'Tap' buttons simultaneously while turning on the amp. Continue holding the buttons until the reset process begins. This will restore all settings to their original factory default.
Ensure that the volume is turned up on both the guitar and the amplifier. Check if the correct input is selected and the cable is securely connected. Also, inspect if the headphone jack is not in use. If the problem persists, try using different cables and a different guitar to rule out external issues.
Yes, you can connect external effects pedals to the Mustang GT40. Connect your guitar to the pedals and then run a cable from the pedal output into the amp's input. Adjust the amp and pedal settings to achieve your desired sound.
Turn on the amplifier and press the Bluetooth button until the LED starts flashing. On your smartphone, enable Bluetooth and search for available devices. Select 'Mustang GT40' from the list to pair the devices. Once paired, the LED will stop flashing.
Ensure your device is within range and not experiencing interference from other electronics. Restart both the amplifier and your device. Unpair and re-pair the devices through the Bluetooth settings. Consider updating the firmware of the amp for improved connection stability.
To save a preset, adjust the settings to your liking and press the 'Save' button. Use the 'Encoder' to select a preset slot and press 'Save' again to confirm. To recall a preset, turn the 'Encoder' to navigate through saved presets and press it to select the desired preset.