Dyson DC17 Absolute Owner’s Manual

To clean the filters, remove them from the vacuum, rinse under cold water until the water runs clear, and let them air dry for at least 24 hours before reinserting.
Check for blockages in the hose, wand, and brush bar. Clean the filters and ensure the dust bin is empty.
Replace the belt if it is damaged or if the brush bar stops spinning effectively, usually every 6-12 months depending on usage.
Check for blockages in the brush bar or hose and ensure the filters are clean. Examine the belt for wear and tear.
Turn off and unplug the vacuum. Detach the hose and wand and use a long object to gently push out the blockage. Clean the brush bar and check for debris.
No, the HEPA filter is not washable. Replace it every 12 months to maintain optimal performance.
Regularly check the brush bar for hair and debris. Use scissors to cut away tangled hair and ensure it spins freely.
Press the release button to remove the bin, hold it over a trash can, and press the red button to empty. Close the bin before reinserting.
Ensure the brush control is set to 'on'. Check for obstructions and verify that the belt is intact and properly aligned.
Ensure the vacuum is plugged in and check the fuse or circuit breaker. Inspect the power cord for damage and ensure the power button is functioning.