Clarke 7333060 Jetstar 1800 Power Instructions

To start the Clarke 7333060 Jetstar 1800 Power Washer, first ensure it is connected to a water supply and the power outlet. Turn the water on, press the power switch to the 'ON' position, and squeeze the trigger on the spray gun to release air from the system.
If the power washer does not start, check the power supply and ensure it is plugged in properly. Verify that the power switch is in the 'ON' position. Check for any blown fuses or tripped circuit breakers.
For low pressure issues, check for clogged nozzles or filters. Ensure the water supply is adequate and there are no kinks in the hose. Clean or replace the nozzle if necessary.
Regularly inspect hoses and connections for wear or damage. Clean the water inlet filter and nozzle regularly to prevent clogs. Store the power washer in a dry place to prevent corrosion.
To store the power washer during winter, drain all water from the unit to prevent freezing. Disconnect hoses and store them indoors. Keep the power washer in a dry, covered area.
Yes, you can use detergent with the Clarke 7333060 Jetstar 1800. Use the detergent tank and follow the manufacturer's instructions for proper dilution and application.
For cleaning concrete surfaces, use a high-pressure nozzle, typically a 15-degree or 25-degree nozzle, to effectively remove dirt and grime.
Check the oil level in the power washer before each use to ensure it is at the recommended level. This helps maintain optimal performance and prevent engine damage.
Always wear protective gear, such as goggles and gloves, when using the power washer. Avoid directing the spray at people, animals, or delicate surfaces.
To replace the spray gun, first disconnect the power and water supply. Unscrew the existing spray gun from the hose and attach the new one securely, ensuring no leaks at the connection point.