Chevrolet Silverado 4500HD 2019 Getting To Know Your Manual
![Chevrolet Silverado 4500HD 2019 manual cover](/images/CGSPjpbHSrsvVsoapAGviJMQ/thumbs/thumb175x175.webp)
To reset the oil life monitor, turn the ignition to the 'On' position without starting the engine. Press the accelerator pedal three times within five seconds. The oil life monitor should reset to 100%.
The recommended tire pressure is usually listed on a sticker inside the driver’s door. For the 2019 Silverado 4500HD, it typically ranges between 60-80 psi depending on the load. Always verify with the vehicle's manual.
Start by checking the gas cap to ensure it is tightly secured, as a loose cap can trigger the light. If the light remains on, use an OBD-II scanner to read the diagnostic trouble codes and address the specific issues.
The 2019 Chevrolet Silverado 4500HD has a towing capacity of up to 21,500 pounds, depending on the configuration and equipment. Always check the owner's manual for specific towing guidelines.
It is generally recommended to change the transmission fluid every 45,000 to 60,000 miles. However, consult your owner's manual for the manufacturer's specific recommendations.
To replace the cabin air filter, locate it behind the glove box. Remove the glove box by releasing the side tabs, then slide out the old filter and insert a new one, ensuring it is positioned correctly according to the airflow direction.
The recommended engine oil for the 2019 Chevrolet Silverado 4500HD is SAE 15W-40 for diesel engines. Always verify with the vehicle's manual to ensure compatibility.
To improve fuel efficiency, maintain proper tire pressure, remove excess weight from the vehicle, ensure regular engine maintenance, and drive at steady speeds. Using cruise control on highways can also help optimize fuel consumption.
Common causes of battery drain include leaving lights on, parasitic draws from electronic devices, a faulty alternator, or a battery that is nearing the end of its life. It's important to diagnose the specific cause to prevent future issues.
To program a new key fob, insert the original key into the ignition and turn it to the 'On' position. Turn it back to 'Off' and remove it. Quickly insert the new key fob and turn it to 'On'. This should program the new fob. Consult the manual for detailed steps.