Chevrolet Colorado 2019 Getting To Know Your Manual

The 2019 Chevrolet Colorado is recommended to use SAE 5W-30 for the best performance. Always refer to the owner’s manual for any specific requirements.
To reset the TPMS on your 2019 Chevrolet Colorado, turn the ignition to the “ON” position without starting the engine. Press and hold the TPMS reset button until the tire pressure light blinks three times, then start the engine and allow the system to reset for about 20 minutes.
The 2019 Chevrolet Colorado has a towing capacity of up to 7,700 pounds when properly equipped with the available Duramax 2.8L Turbo-Diesel engine.
To replace the cabin air filter, locate the filter compartment behind the glove box. Remove the glove box by squeezing its sides inward to lower it. Open the filter compartment, remove the old filter, and insert the new one, ensuring it is properly aligned.
The check engine light can illuminate for various reasons, including a loose gas cap, faulty oxygen sensor, or catalytic converter issues. It is best to use an OBD-II scanner to read the trouble codes or consult a professional mechanic for a precise diagnosis.
It is generally recommended to change the transmission fluid every 45,000 to 60,000 miles under normal driving conditions. Always refer to your owner’s manual for the manufacturer’s specific recommendations.
The recommended tire pressure for the 2019 Chevrolet Colorado is typically 35 PSI for both the front and rear tires. However, always check the placard on the driver’s side door jamb for the most accurate information.
Improving fuel efficiency can be achieved by maintaining proper tire pressure, performing regular maintenance, avoiding excessive idling, and driving at moderate speeds. Removing unnecessary weight and using cruise control on highways can also help.
If your 2019 Chevrolet Colorado won’t start, check the battery connections for corrosion, ensure the battery is charged, and verify that the fuel level is adequate. If the issue persists, a professional diagnostic may be necessary to determine the problem.
To pair your smartphone, turn on Bluetooth on your phone, then go to the Chevrolet MyLink screen, select 'Phone', then 'Pair Device'. Follow the on-screen instructions and confirm the pairing code on your phone.