Candy FR CCV 150 User Manual
![Candy FR CCV 150 manual cover](/images/oKGpihIndNVMYsjpXMxiaSse/thumbs/thumb175x175.webp)
To adjust the temperature settings, locate the control panel inside the cooler. Use the temperature dial to increase or decrease the cooling level to your desired setting.
First, check if the cooler is properly plugged in and the power is on. Ensure the door is closed tightly and the seals are intact. If the problem persists, inspect the condenser coils for dust and clean them if necessary.
The cooler should be defrosted when ice build-up reaches approximately 5mm thick. This typically occurs every few months, depending on usage.
Yes, the cooler is designed to store both food and beverages. However, ensure that the temperature is set appropriately for the items you are storing.
To clean the interior, unplug the cooler and remove all contents. Use a mild soap solution and a soft cloth to wipe down the surfaces. Rinse with clean water and dry thoroughly before returning items.
Unusual noises can be due to the cooler being unlevel, items inside vibrating, or the fan or compressor needing attention. Ensure the cooler is on a stable surface and check internal components for any visible issues.
Keep the cooler well-stocked but not overcrowded, ensure the door seals are tight, and avoid opening the door frequently. Also, place the cooler away from heat sources such as direct sunlight or ovens.
Check the bulb to see if it needs replacing. Ensure the cooler is unplugged before replacing the light bulb. If the new bulb does not work, there may be a wiring issue that requires professional service.
It is not recommended to transport the cooler on its side as this can cause compressor oil to flow into the cooling lines. If it must be transported on its side, allow it to stand upright for at least 24 hours before plugging it in.
After a power outage, unplug the cooler for a few minutes, then plug it back in. Allow the cooler to stabilize for a few hours. If it does not start cooling, check the circuit breaker and ensure the outlet is working.