Candy EVOT 10061D-UK User Manual
![Candy EVOT 10061D-UK manual cover](/images/jwSIOEeHkeQuJjTsobxapkjL/thumbs/thumb175x175.webp)
To reset your Candy EVOT 10061D-UK washing machine, turn the dial to the off position, wait for a few minutes, then turn it back on. This should reset the machine's electronic control.
First, check if the drain hose is kinked or blocked. Clean the pump filter and ensure that there are no obstructions. If the problem persists, inspect the pump for any damage.
Remove the detergent drawer by pressing the release lever. Rinse it under warm water to remove any detergent buildup. Use a soft brush to clean hard-to-reach areas before reinserting it.
Perform a maintenance wash every month by running an empty load with a washing machine cleaner or vinegar. Regularly clean the door seal and filter, and check hoses for any signs of wear.
Ensure the washing machine is level by adjusting the feet. Check that the load is balanced and avoid overloading. Consider using anti-vibration pads if the issue persists.
Wait a few minutes for the machine to cool down as it may be in a lock mode. Check if the water has completely drained. If necessary, manually release the door using the emergency release cord.
Use the correct amount of detergent and avoid washing very small or large loads. Regularly clean the filter and use energy-saving cycles whenever possible.
This could be due to a power interruption or a tripped circuit breaker. Inspect the door latch and ensure it is properly closed. Also, check for any error codes displayed on the machine.
Ensure that the spin speed is set correctly for the type of laundry. Check for any blockages in the pump filter and ensure the drain hose is not obstructed.
Run a hot water cycle with a washing machine cleaner or vinegar to eliminate odors. Clean the door seal and detergent drawer regularly to prevent mold and mildew buildup.