Candy CSO 1275TBE 1-S User Manual
![Candy CSO 1275TBE 1-S manual cover](/images/ofFJCPwSUGSWFqEUamlpSKAK/thumbs/thumb175x175.webp)
To start a wash cycle, load your laundry into the drum, add detergent, close the door, select the desired wash program using the dial, and press the start button.
Ensure the machine is plugged in and switched on. Check that the door is properly closed. Verify that the water supply tap is open and the start button was pressed.
Remove the detergent drawer by pulling it out until it stops, then press down on the release lever. Wash the compartments with warm water and a soft brush, then replace it.
Error code E03 indicates a drainage issue. Check for blockages in the drain hose and pump filter, and ensure the drain hose is positioned correctly.
Regularly clean the detergent drawer, check and clean the pump filter, inspect the door seal for debris, and run a maintenance wash with an empty drum and a descaler.
Excessive vibration can be caused by an unbalanced load. Ensure the machine is level and the laundry is evenly distributed. Avoid overloading the drum.
Yes, use the delicate or hand wash program for delicate fabrics. Place items in a mesh laundry bag to protect them during the wash.
Use eco-friendly wash cycles, wash full loads when possible, and opt for lower temperature settings to reduce energy consumption.
Check for blockages in the pump filter and drain hose. Make sure the hose is not kinked and is positioned at the correct height.
To reset the machine, turn it off and unplug it for a few minutes. Plug it back in and turn it on to see if the issue is resolved.