Candy CBW 47D1E-80 User Manual

To start a wash cycle, load your laundry into the drum, add detergent, close the door, select the desired wash program using the control knob, and press the start button.
First, check if the drain hose is clogged or kinked. Ensure the pump filter is clean. Refer to the user manual for cleaning instructions. If the problem persists, contact a technician.
Remove the detergent drawer by pulling it out and pressing the release lever. Wash it under warm water to remove any residue and let it dry before reinserting it.
Excessive vibration can be due to an unbalanced load. Make sure the washing machine is level and that the laundry is evenly distributed in the drum.
To reset the machine, turn the dial to the 'Off' position, wait a few seconds, and then turn it back to your desired program. This should reset any minor issues.
It is recommended to clean the pump filter and detergent drawer monthly, check and clean the door seal regularly, and perform an empty hot wash with washing machine cleaner every few months.
Leave the door slightly ajar after each wash to allow the drum to dry. Regularly clean the door seal and do an occasional hot wash with a machine cleaner.
Ensure the machine is plugged in and the door is closed properly. Check the fuse and circuit breaker. If the issue remains, consult the user manual or contact support.
Use the ECO wash programs, wash with full loads, and select lower temperature settings when possible to reduce energy consumption.
Run an empty hot wash with a washing machine cleaner. Clean the door seal and detergent drawer, and ensure the drum is left open after each wash to air out.