Candy BCBS 172 TK N User Manual
![Candy BCBS 172 TK N manual cover](/images/IlbMyVsFRLJYVsRyBdufohSU/thumbs/thumb175x175.webp)
To adjust the temperature settings, locate the thermostat dial inside the refrigerator compartment. Turning the dial towards the higher numbers will lower the temperature, while turning it to lower numbers will raise the temperature.
First, check if the refrigerator is plugged in and the power is on. Ensure the thermostat is set correctly. Also, check the door seals for any gaps and clean the condenser coils to improve cooling efficiency.
Defrost the freezer compartment whenever the ice build-up exceeds 5mm. This helps maintain the efficiency of the appliance and prevents overworking the compressor.
Use a soft cloth and a mild detergent mixed with warm water to wipe down the interior surfaces. Avoid using abrasive cleaners or sharp objects that could damage the surfaces.
Regularly clean the refrigerator and remove expired food items. Use a box of baking soda to absorb odors, and ensure containers are sealed properly to prevent leakage.
Water pooling can be due to a blocked defrost drain. Clean the drain using a mixture of baking soda and warm water. Ensure the fridge is level to allow proper drainage.
First, unplug the refrigerator. Remove the light cover by unscrewing or unclipping it, then replace the bulb with a new one of the same type and wattage. Reattach the cover and plug the refrigerator back in.
Check for obstructions in the door gasket and ensure the refrigerator is level. If needed, adjust the door hinges to improve alignment and sealing.
Keep the refrigerator away from heat sources, ensure the door seals are intact, avoid overfilling, and maintain the recommended temperature settings to enhance energy efficiency.
Locate the water filter compartment, usually at the back or inside the refrigerator. Turn off the water supply, remove the old filter by turning it counterclockwise, and install the new filter by turning it clockwise until it locks. Turn the water supply back on and check for leaks.