Bosch Series 6 SMV6ZCX01G Quick Instruction Guide
![Bosch Series 6 SMV6ZCX01G Dishwasher manual cover](/images/qlYsdAiFLssOtaqZezTCcsXC/thumbs/thumb175x175.webp)
To reset your Bosch Series 6 dishwasher, press and hold the Start button for approximately 3 seconds until the display shows "0:01" or "End". This will cancel the current cycle and reset the machine.
Ensure that the drain hose is not kinked or blocked. Check the filter for clogs and clean it if necessary. If the problem persists, inspect the pump for obstructions.
Remove the lower rack, twist the filter cap counterclockwise, and lift it out. Rinse the filter under running water to remove debris. Replace it by aligning it in the holder and twisting clockwise.
The "Check Water" error indicates a problem with water supply. Ensure the water tap is fully open, the hose is not kinked, and the inlet filter is clean. Check for leaks or obstructions in the hose.
Place large items at the sides and back, ensuring they do not block the spray arms. Position pots and pans upside down. Avoid overloading and mix cutlery for better cleaning.
Residue can result from using too much or too little detergent, hard water, or a clogged spray arm. Use the recommended detergent amount, check water hardness settings, and clean the spray arms.
Clean the spray arms every few months or if you notice blockages affecting cleaning performance. Remove them by unscrewing or unclipping, and rinse under water to clear debris.
Yes, you can use vinegar for cleaning. Place a cup of vinegar in a dishwasher-safe container on the top rack and run a hot water cycle to remove odors and mineral buildup.
Check for obstructions around the door, racks, and seals. Ensure that no items are protruding from the racks. Inspect the door latch for damage or misalignment.
Ensure the Rinse Aid dispenser is filled, as it helps with drying. Use the Extra Dry option if available, and open the door slightly after the cycle to release steam.