BMW R 1200RT 2016 Rider's Manual

To perform an oil change, warm up the engine to ensure the oil flows out easily. Place the motorcycle on the center stand, remove the oil filler cap, and drain plug. Replace the oil filter and drain plug washer, then refill with the recommended oil type and quantity.
The recommended tire pressure for the front tire is 36 psi (2.5 bar) and for the rear tire is 42 psi (2.9 bar). Always check tire pressure when the tires are cold.
Start by checking the ABS sensor connections at both wheels for dirt or damage. Ensure the battery is fully charged, as low voltage can affect ABS function. If issues persist, a diagnostic tool may be necessary to read fault codes.
The service interval for the BMW R 1200RT 2016 is every 6,000 miles or 12 months, whichever comes first. This includes oil changes, valve clearance checks, and other routine maintenance tasks.
The windshield on the BMW R 1200RT 2016 can be adjusted electronically. Use the handlebar-mounted switch to raise or lower the windshield to your preferred position while the motorcycle is stationary or moving at low speeds.
Use DOT 4 brake fluid for the BMW R 1200RT 2016. Always ensure the brake fluid is from a sealed container to prevent moisture contamination.
To reset the service light, you will need a diagnostic tool such as the GS-911 or visit a BMW dealership. The tool will allow you to access the bike’s computer system and reset the service indicator.
To improve fuel efficiency, maintain proper tire pressure, use high-quality fuel, and ensure regular maintenance such as air filter and spark plug replacements. Riding smoothly and avoiding rapid acceleration can also help.
For winter storage, clean the motorcycle thoroughly, change the oil, and add a fuel stabilizer. Disconnect the battery and store it in a cool, dry place. Inflate tires to the correct pressure and cover the bike to protect it from dust and moisture.
To replace the headlight bulb, remove the cover from the back of the headlight assembly, disconnect the electrical connector, and remove the old bulb. Insert the new bulb, reconnect the connector, and replace the cover. Ensure not to touch the glass part of the new bulb with bare hands.