BMW G 450 X 2008 Rider's Manual

To break in the engine, avoid full throttle starts and vary the engine speed. Keep the RPMs low for the first 600 miles and gradually increase it. After the break-in period, change the oil and check the valve clearance.
The recommended oil type is SAE 10W-40 synthetic motorcycle oil. The oil capacity is approximately 1.15 liters. Always check the owner’s manual for specific requirements.
Check the battery charge and connections, inspect the spark plug for wear or fouling, and ensure the fuel is fresh and reaching the engine. If these are fine, check the starter motor and related electrical components.
The recommended tire pressure is 22 psi for the front tire and 25 psi for the rear tire. Always adjust according to load and riding conditions.
Clean and lubricate the chain every 500 miles or after riding in wet or dusty conditions. Check for proper tension and adjust as needed.
Symptoms include difficulty shifting gears, a slipping clutch when accelerating, and a burning smell. If you experience any of these, inspect the clutch plates and springs.
Adjust the suspension by setting the preload, rebound, and compression damping according to your weight and riding style. Refer to the owner's manual for specific settings and procedures.
Clean the motorcycle thoroughly, change the oil, add a fuel stabilizer, disconnect the battery, and inflate the tires to the recommended pressure. Store in a dry, covered area.
To reset the service light, use a diagnostic tool compatible with BMW motorcycles or visit a BMW service center. The reset procedure typically involves accessing the ECU and clearing the service reminder.
The recommended spark plug is NGK CR9EB. It should be inspected every 6,000 miles and replaced every 12,000 miles or if it shows signs of wear or damage.