BMW F 750 GS 2020 Rider's Manual

The recommended tire pressure for the BMW F 750 GS 2020 is 36 psi (2.5 bar) for the front tire and 42 psi (2.9 bar) for the rear tire when riding with a solo rider. Adjustments may be needed for different load conditions.
It is recommended to change the engine oil and oil filter every 6,000 miles (10,000 kilometers) or annually, whichever comes first, for optimal performance and longevity of your BMW F 750 GS 2020.
The BMW F 750 GS 2020 requires a high-quality synthetic motorcycle oil with a viscosity rating of SAE 5W-40. It is important to use oil that meets the API SL specification or higher.
To reset the service light on a BMW F 750 GS 2020, you will need to use a diagnostic tool, such as a GS-911 or have it reset at a BMW Motorrad dealership. This cannot be manually reset without specialized equipment.
The chain tension for the BMW F 750 GS 2020 should be adjusted to allow for 35-45 mm of slack in the middle of the chain run, measured on the side stand. Regular checking and adjustment are crucial for safe riding.
To improve the fuel efficiency of your BMW F 750 GS 2020, ensure regular maintenance, keep tires properly inflated, use high-quality fuel, avoid aggressive riding, and reduce excess weight.
Common issues with the BMW F 750 GS 2020 may include electrical system glitches, such as faulty sensors, and occasional clutch adjustments. Regular servicing and diagnostics can help prevent these issues.
To adjust the suspension on a BMW F 750 GS 2020, use the preload adjuster for the rear shock located under the seat for load adjustments. The front suspension is non-adjustable, so any changes would require aftermarket solutions.
During the break-in period of the first 600 miles (1,000 kilometers), avoid full-throttle starts and excessive engine revving. Vary engine speeds and avoid long periods at constant RPMs to ensure proper engine bedding.
To change the headlight bulb on a BMW F 750 GS 2020, first remove the headlight cover by releasing the clips, then disconnect the electrical connector. Remove the old bulb by twisting it counterclockwise and replace it with a new bulb, ensuring not to touch the glass.