Acura ILX Hybrid Tech HomeLink 2013 Manual

To program the HomeLink system, first, ensure your vehicle is parked outside the garage. Turn the ignition to the ACC position. Press and hold the desired HomeLink button and the remote control button simultaneously until the HomeLink indicator changes from a slow to a rapid blink. Release both buttons.
If HomeLink is not responding, try resetting the system by holding the two outer HomeLink buttons until the indicator light begins to flash. Reprogram the buttons using the garage door remote. Ensure the remote's battery is fresh.
Regular maintenance should be performed every 5,000 to 7,500 miles, including oil changes, tire rotations, and brake inspections. Check your owner's manual for the specific service schedule.
The recommended oil type for the 2013 Acura ILX Hybrid Tech is 0W-20 full synthetic oil. This helps ensure optimal performance and efficiency.
To improve fuel efficiency, ensure your tires are properly inflated, perform regular maintenance, use the ECO driving mode, and avoid excessive idling and rapid acceleration.
Unusual noises during braking could indicate worn brake pads or rotors. It's advisable to have the brake system inspected by a professional to ensure safety and proper function.
To jump-start, connect the positive cable to your battery's positive terminal and the donor battery's positive terminal. Connect the negative cable to the donor battery's negative terminal and an unpainted metal surface on your vehicle. Start the donor vehicle, then your ILX.
To reset the maintenance light, turn the ignition to the ON position without starting the engine. Use the steering wheel buttons to navigate to the Maintenance Minder screen. Press and hold the SEL/RESET button until the maintenance reset screen appears, then select RESET.
Common causes include a loose gas cap, faulty oxygen sensor, malfunctioning catalytic converter, or issues with the ignition system. A diagnostic scan can provide specific error codes for troubleshooting.
To replace the cabin air filter, open the glove box and remove the retaining arm. Press the sides of the glove box inward to lower it completely. Locate and remove the cabin filter cover, then replace the old filter with a new one, ensuring it is oriented correctly.