Acctim Skyler 16162 Operating Instructions
![Acctim Skyler 16162 manual cover](/images/60e656cd970e42b120ac0ed3/thumbs/thumb175x175.webp)
To set the time, press and hold the 'Set' button until the time digits start flashing. Use the 'Up' and 'Down' buttons to adjust the hours and minutes. Press 'Set' again to confirm and exit the setting mode.
Press the 'Alarm' button and hold it until the alarm time flashes. Adjust the alarm time using the 'Up' and 'Down' buttons. Press 'Alarm' again to confirm the changes.
Check the battery compartment to ensure the batteries are installed correctly and have sufficient charge. If the problem persists, try resetting the clock by removing and reinserting the batteries.
To activate the alarm, press the 'Alarm On/Off' button until the alarm indicator appears on the display. To deactivate, press the same button until the indicator disappears.
Yes, you can adjust the brightness by using the brightness control button. Press it to switch between different brightness levels.
To replace the batteries, open the battery compartment cover located at the back of the clock. Remove the old batteries and insert new ones, ensuring the polarity matches the markings inside the compartment.
To reset the clock, remove the batteries, wait for at least 10 seconds, and then reinsert them. This will reset all settings to their default values.
Ensure that the daylight saving time (DST) function is enabled. Check the manual for instructions on how to enable this feature, as it may require setting it through the clock's menu.
To temporarily mute the alarm, press the 'Snooze' button. This will silence the alarm for a few minutes, after which it will sound again if not turned off.
If the clock is unresponsive, check the battery compartment for correct installation and battery life. Try a reset by removing and reinserting the batteries. If the problem continues, consult the user manual or contact customer support.