Yamaha XV250A1 C Star 2011 Owner's Manual
![Yamaha XV250A1 C Star 2011 manual cover](/images/af82b1c337e2660575751d2e/thumbs/thumb175x175.webp)
To change the oil, first warm up the engine. Then, place the motorcycle on a level surface and remove the oil filler cap. Place a drain pan under the engine and remove the drain bolt. Allow the oil to fully drain, replace the drain bolt, and refill with the recommended oil grade.
Use a high-quality 4-stroke motorcycle oil of SAE 10W-40 or 20W-50, depending on temperature conditions. Ensure it's API service SG type or higher.
Inspect the air filter every 3,000 miles and clean it if necessary. Replace the air filter every 12,000 miles, or more frequently if riding in dusty conditions.
The recommended tire pressure is 28 psi for the front tire and 32 psi for the rear tire. Always check and adjust tire pressure when the tires are cold.
If experiencing starting issues, check the battery charge, ensure the kill switch is in the 'Run' position, inspect the spark plugs for fouling, and make sure the fuel valve is open.
If the engine overheats, stop the motorcycle, and allow it to cool down. Check for coolant levels and refill if necessary. Inspect the radiator and hoses for leaks or obstructions.
To adjust the chain tension, place the motorcycle on its center stand, loosen the rear axle nut, and adjust the chain adjusters equally on both sides until the chain has 20-30 mm of slack. Tighten the axle nut securely.
The correct spark plug gap for the Yamaha XV250A1 C Star 2011 is 0.7-0.8 mm (0.028-0.031 inches). Use a feeler gauge to check and adjust the gap if necessary.
To replace the brake pads, first remove the caliper from the disc. Remove the old pads and clean the caliper. Insert the new pads and reattach the caliper, ensuring proper alignment. Test the brakes before riding.
Regular maintenance checks should include inspecting the oil level, checking the condition of tires and brakes, examining the lights and signals, and ensuring proper chain tension. Additionally, inspect the cables and clutch for wear and adjust as necessary.