Yamaha XTZ12EK, XTZ12EKC Super Tenere ES 2019 Owner's Manual
![Yamaha XTZ12EK, XTZ12EKC Super Tenere ES 2019 manual cover](/images/69fc5ad8655358c485da0724/thumbs/thumb175x175.webp)
The recommended tire pressure for the Yamaha Super Tenere ES 2019 is 33 psi for the front tire and 36 psi for the rear tire.
The engine oil should be changed every 4,000 miles or 6,000 kilometers, or at least once a year. Always use oil that meets Yamaha specifications.
Yamaha recommends using a high-quality ethylene glycol-based antifreeze coolant with corrosion inhibitors for aluminum engines.
The Yamaha Super Tenere ES 2019 features electronic suspension that can be adjusted through the on-board menu. Navigate to the suspension settings and choose from pre-set modes or customize according to your preference.
If the ABS warning light remains on, it could indicate a fault in the ABS system. Check the fuses and connections, and consult a Yamaha dealer for a detailed diagnosis if the issue persists.
Regularly inspect the drive shaft for any signs of wear or damage. Lubricate the splines and ensure the protective boot is intact to prevent debris from entering.
To check the battery, first ensure the ignition is off. Remove the seat to access the battery compartment, then use a multimeter to check the voltage. A fully charged battery should read around 12.6 volts.
Start by checking the battery voltage and connections. Ensure the kill switch is in the run position and the kickstand is up. If the issue persists, inspect the starter relay and ignition switch.
Regularly check the brake pads for wear and replace them if necessary. Inspect the brake fluid level and top up with the recommended DOT 4 brake fluid if needed. Brake lines should also be checked for any signs of wear or leakage.
Remove the air filter cover to access the air filter. Clean the filter by gently tapping it to remove dust or use compressed air. If the filter is heavily soiled or damaged, replace it with a new one.