Yamaha PW50G2 PW50 2017 Owner's Manual
![Yamaha PW50G2 PW50 2017 manual cover](/images/6d783014bc85c85227aea72a/thumbs/thumb175x175.webp)
The Yamaha PW50G2 PW50 2017 uses regular unleaded gasoline with a minimum octane rating of 87. Avoid using ethanol-blended fuels higher than 10%.
It is recommended to change the oil every 6 months or every 30 hours of riding, whichever comes first, to ensure optimal performance and longevity of the engine.
The recommended spark plug for the Yamaha PW50G2 PW50 2017 is the NGK BPR4HS or equivalent. Ensure the spark plug gap is set to 0.6 - 0.7 mm.
To adjust the carburetor, locate the air screw and throttle stop screw. Start by turning the air screw 1.5 turns out, then adjust the throttle stop screw to achieve a stable idle speed. Fine-tune as necessary.
The recommended tire pressure for the Yamaha PW50G2 PW50 2017 is 15 psi for both the front and rear tires. Regularly check and maintain proper tire pressure for safe riding conditions.
To store your bike during the off-season, clean it thoroughly, change the oil, drain the fuel, and remove the spark plug. Apply a small amount of oil into the cylinder and replace the spark plug. Store the bike in a dry, covered area.
First, check the fuel level and ensure the fuel valve is open. Verify the spark plug is clean and properly gapped. If these steps do not resolve the issue, inspect the ignition system and carburetor for any faults.
To adjust the throttle cable, locate the adjuster at the throttle grip. Loosen the locknut and turn the adjuster until there is 2-3 mm of free play in the throttle grip. Tighten the locknut once adjusted.
Ensure the brake shoes are not worn out and adjust the brake lever free play. Clean the braking surfaces and replace the brake shoes if necessary for improved performance.
The recommended chain tension is 15-25 mm of slack at the midpoint of the chain. Regularly check and adjust the chain tension to maintain proper drivetrain function.