Yamaha FZ6RA C FZ6R 2011 Owner's Manual
![Yamaha FZ6RA C FZ6R 2011 manual cover](/images/5c8fead3384a24c6a6a359ff/thumbs/thumb175x175.webp)
To perform an oil change on your Yamaha FZ6RA C FZ6R, first warm up the engine for a few minutes to thin the oil. Place a drain pan under the engine, remove the oil drain bolt and let the oil drain completely. Replace the drain bolt and remove the oil filter. Install a new oil filter, ensuring it is properly seated and lubricated. Refill with the recommended type and amount of oil, then check the oil level using the dipstick.
If your FZ6R won't start, check the battery connections for corrosion and ensure they are tight. Verify the kill switch is in the "run" position and that you have sufficient fuel. Inspect the fuses and replace any that are blown. If these steps don't work, the issue might be more complex, requiring professional diagnosis.
Yamaha recommends checking the air filter every 6,000 miles and replacing it every 12,000 miles or sooner if riding in dusty conditions.
For the 2011 Yamaha FZ6R, the recommended tire pressure is 36 psi for the front tire and 42 psi for the rear tire. Always check the pressure when the tires are cold.
To adjust the chain tension, place the bike on a stand and locate the chain adjusters on the swingarm. Loosen the axle nut and turn the adjusters evenly on both sides to achieve the recommended slack of about 1.2–1.6 inches. Retighten the axle nut and recheck the tension.
If the engine overheats, pull over safely and turn off the engine. Allow it to cool before checking the coolant level. Inspect for leaks or blockages in the radiator and hoses. If the coolant is low, refill with a 50/50 mix of coolant and distilled water. Seek professional help if the problem persists.
To improve fuel efficiency, maintain proper tire pressure, ensure regular maintenance such as oil and air filter changes, avoid excessive idling, and ride at steady speeds. Avoid aggressive acceleration and braking.
Before storing your FZ6R, clean the bike thoroughly, change the oil and filter, top off the fuel tank and add a fuel stabilizer, inflate the tires to the recommended pressure, and disconnect the battery. Store the bike in a cool, dry place, preferably on stands to avoid flat spots on the tires.
To adjust the suspension on your FZ6R, refer to the owner’s manual for the recommended settings. Use a spanner wrench to adjust the rear preload by turning the adjuster ring. For the front forks, adjustments can typically be made using a screwdriver for preload and rebound settings.
Blue smoke from the exhaust indicates oil burning, which could be due to worn piston rings, valve seals, or other engine components. It is advisable to have your motorcycle inspected by a professional mechanic to diagnose and resolve the issue.