Toro S200 38130 Operator's Manual

To start the Toro S200 38130, ensure the throttle is set to 'fast,' the choke is engaged, and the fuel valve is open. Pull the starter handle firmly until the engine starts. Disengage the choke gradually as the engine warms up.
Use fresh, clean, unleaded gasoline with an octane rating of 87 or higher. Avoid using gasoline with more than 10% ethanol.
The spark plug should be inspected and cleaned at the start of each snow season. Replace the spark plug at least once a year or more frequently if the engine performance decreases.
Perform a thorough inspection before each use, checking for loose nuts and bolts. Change the engine oil every 25 hours of operation or at the end of each snow season. Clean the air filter and check the scraper bar and paddles regularly.
Ensure the fuel valve is open, and there is fresh fuel in the tank. Check the spark plug for damage and clean or replace it if necessary. Verify that the choke is engaged and the throttle is set correctly.
To adjust the scraper bar, loosen the mounting bolts and slide the bar to the desired position. Ensure it is even with the ground for optimal snow removal. Tighten the bolts securely after adjustment.
Check if the chute is clogged and clear any obstructions. Inspect the paddles for wear and replace them if necessary. Ensure the engine is running at full throttle for maximum performance.
Drain the fuel tank and run the engine until it stops. Clean the machine thoroughly and store it in a dry, protected area. Cover the snow thrower to prevent dust accumulation.
Remove the bolts securing the paddles and take off the old paddles. Align the new paddles with the holes and secure them with bolts. Verify they are tight and properly installed.
Regular maintenance, including oil changes, spark plug inspection, and keeping the paddles and scraper bar in good condition, can enhance performance. Also, ensuring the engine runs at full throttle will provide optimal snow throwing capability.