Toro Recycler 53-cm 20789 Operator's Manual

To start the Toro Recycler 53-cm 20789 Mower, ensure the fuel tank is filled, the spark plug is connected, and the oil level is adequate. Then, pull the safety bar towards the handle and use the recoil starter to start the engine by pulling the cord swiftly.
If the mower doesn't start, check the fuel level and ensure it's fresh. Verify that the spark plug is clean and properly connected. Also, inspect the air filter for clogs and ensure the safety bar is fully engaged.
To maintain the cutting blade, regularly inspect it for damage and sharpness. Sharpen the blade every 20-25 hours of use or more frequently if needed. Always disconnect the spark plug before performing any blade maintenance.
To clean the mower, disconnect the spark plug and tilt the mower to access the underside. Use a brush or hose to remove grass clippings and debris. Ensure the mower is dry before storing to prevent rust.
Change the oil after the first 5 hours of use and then every 25 hours or at the start of each mowing season. Use the recommended oil type as specified in the user manual.
Excessive vibration could be due to an unbalanced or damaged blade. Inspect the blade and replace if necessary. Also, check for debris lodged in the cutting area or loose parts.
Adjust the cutting height by using the height adjustment levers located on each wheel. Ensure all wheels are set to the same height for an even cut.
It is not recommended to use the mower on wet grass as it can lead to uneven cuts, clogging, and potential damage to the mower. Wait until the grass is dry for best results.
For off-season storage, clean the mower thoroughly, drain the fuel, and remove the spark plug. Store the mower in a dry, sheltered area to protect it from the elements.
If the self-propel system isn't working, check the drive belt for wear or damage and ensure it's properly tensioned. Also, inspect the drive cable for any signs of wear or breakage.