Toro Recycler 53-cm 20764BC Operator's Manual
![Toro Recycler 53-cm 20764BC Mower manual cover](/images/ZOkjeyJbqdYbRuKjWxXYpgnK/thumbs/thumb175x175.webp)
To start the Toro Recycler 53-cm 20764BC Mower, ensure the fuel tank is filled, the oil level is correct, and the spark plug is connected. Pull the starter rope slowly until you feel resistance, then pull rapidly to start the engine.
Check if there is enough fuel in the tank and the oil level is adequate. Ensure the spark plug is clean and properly connected. If the mower still does not start, inspect the air filter and clean or replace it if necessary.
Sharpen the mower blades at least once a season or after every 25 hours of use to ensure a clean cut. Dull blades can damage grass and strain the engine.
After use, let the mower cool down, then use a garden hose to rinse off grass clippings. Avoid spraying water directly into the engine. Dry the mower thoroughly to prevent rust.
To change the oil, run the engine for a few minutes to warm it up, then turn it off. Remove the oil fill cap and tip the mower on its side to drain the old oil into a container. Replace with new oil and secure the oil fill cap.
Use SAE 30 or 10W-30 oil for optimal performance in the Toro Recycler 53-cm 20764BC Mower. Always check the owner’s manual for specific recommendations.
Adjust the cutting height by using the height adjustment levers located on each wheel. Ensure all wheels are set to the same height for an even cut.
Uncut strips of grass may be due to dull blades or an uneven deck. Sharpen the blades and check if the deck is level. Also, ensure the mower is not moving too quickly over the grass.
During the off-season, clean the mower thoroughly, change the oil, and inspect the blades. Store the mower in a dry, covered area, and remove the spark plug to prevent accidental starting.
Excessive vibration can be caused by unbalanced blades, debris stuck under the deck, or loose parts. Check and balance the blades, clean the deck, and tighten any loose components.