Toro Recycler 22-inch 20023C Operator's Manual
![Toro Recycler 22-inch 20023C Mower manual cover](/images/ajTZfbqFaBjdWUJkCbcickQs/thumbs/thumb175x175.webp)
To start the Toro Recycler 22-inch 20023C mower, ensure the mower is on a flat surface. Check that the fuel tank is filled and the oil level is adequate. Pull the safety bar towards the handle and use the recoil starter to start the engine.
The Toro Recycler 22-inch mower typically requires SAE 30 oil for temperatures above 32°F (0°C) and 10W-30 for colder temperatures. Always check the owner's manual for specific recommendations.
Blades should be sharpened at least once a mowing season or after approximately 25 hours of usage. More frequent sharpening may be necessary if you mow over rough or sandy terrain.
If the mower won't start, check the fuel level, spark plug condition, and air filter. Ensure the safety bar is engaged and the recoil starter is functioning properly. If these are all in order, consider checking the carburetor for clogs.
To improve mulching, ensure the blade is sharp and the deck is clean. Mow when the grass is dry and avoid cutting more than one-third of the grass height at a time.
To change the air filter, locate the air filter cover on the side of the engine. Remove the cover, take out the old filter, and replace it with a new one. Ensure the new filter is securely in place before closing the cover.
Excessive vibration could be due to an unbalanced blade, loose engine bolts, or debris lodged in the mower deck. Inspect the blade for damage and balance it if necessary. Check all fasteners and clear any debris.
To clean the deck, ensure the mower is off and disconnect the spark plug. Tilt the mower carefully and use a brush or scraper to remove grass clippings and debris. A garden hose can be used for additional cleaning.
For winter storage, run the mower until the fuel is depleted, or use a fuel stabilizer. Clean the mower thoroughly, change the oil, and remove the spark plug. Store the mower in a dry, sheltered location.
The cutting height can be adjusted using the levers located on each wheel. Move the levers to the desired height setting, ensuring all wheels are set to the same level for an even cut.