Toro Recycler 21-inch 20218 Operator's Manual
![Toro Recycler 21-inch 20218 Mower manual cover](/images/hPTexARhGnJkfoPEmuuIFNzB/thumbs/thumb175x175.webp)
To start the Toro Recycler 21-inch 20218 Mower, ensure the fuel tank is filled and the oil level is adequate. Press the primer bulb three times if the engine is cold. Hold the blade control bar against the handle, then pull the starter rope to start the engine.
Use SAE 30 oil for temperatures above 32°F (0°C) and SAE 5W-30 or 10W-30 for temperatures below 32°F (0°C). Always check the oil level before each use and change the oil after the first 5 hours of operation, then annually or every 50 hours, whichever comes first.
To adjust the cutting height, move the height adjustment levers located near each wheel. Ensure all four wheels are set to the same height for an even cut. The height can be adjusted between 1 inch to 4 inches.
If your mower won't start, check the fuel level and quality. Make sure the spark plug is clean and properly connected. Ensure the air filter is clean, and that the oil level is correct. If the issue persists, consult the user manual or contact a professional technician.
Sharpen the mower blade at least once per mowing season or after every 25 hours of use. A sharp blade ensures a clean cut and promotes lawn health. Always disconnect the spark plug wire before servicing the blade.
To clean your mower, ensure it is off and the spark plug wire is disconnected. Use a brush to remove grass clippings from the deck. If necessary, use a hose to wash underneath, but avoid getting water on the engine. Dry the mower thoroughly before storage.
To change the air filter, locate the air filter cover on the side of the engine. Remove the cover and replace the old filter with a new one. Ensure the new filter is seated properly before reattaching the cover.
To store your mower for winter, clean it thoroughly and drain the fuel system. Change the oil and remove the spark plug to add a few drops of oil into the cylinder. Pull the starter rope a few times to distribute the oil, then replace the spark plug. Store in a dry, covered location.
To replace the spark plug, disconnect the spark plug wire and use a spark plug wrench to remove the old plug. Insert a new spark plug, ensuring it is properly gapped according to the user manual, and tighten it securely. Reattach the spark plug wire.
Excessive vibration may indicate a bent blade, loose parts, or engine issues. Inspect the blade for damage and ensure all nuts and bolts are tight. If the problem persists, consult a professional technician for further diagnosis.