Toro Recycler 20450 Operator's Manual

To start the Toro Recycler 20450 Mower, first ensure the fuel shut-off valve is open and the spark plug is connected. Prime the engine by pressing the primer bulb three times. Pull the starter handle firmly until the engine starts.
Use SAE 30 or SAE 10W-30 oil for the Toro Recycler 20450 Mower, depending on the temperature range in your area. Refer to the owner's manual for specific recommendations.
Change the oil after the first 5 hours of operation and then every 50 hours or at least once per mowing season.
To clean the undercarriage, ensure the mower is off and cool. Tilt the mower onto its side with the air filter facing up. Use a brush or hose to remove grass clippings and debris.
Check the fuel level and add fresh fuel if needed. Ensure the spark plug is connected and clean. Inspect the air filter for clogs and clean or replace it if necessary.
Disconnect the spark plug wire. Remove the blade by loosening the bolt holding it in place. Use a file or bench grinder to sharpen the blade, maintaining the original angle. Reattach the blade securely.
Drain the fuel tank or add fuel stabilizer. Clean the mower thoroughly, including the undercarriage. Change the oil and remove the spark plug to add a few drops of oil into the cylinder. Store in a dry place.
To adjust the cutting height, locate the height adjustment levers on each wheel. Move the levers to the desired height setting, ensuring all wheels are set to the same level.
Regularly check and clean the air filter, change the oil every 50 hours, sharpen the blade annually, and inspect the mower for any loose parts or damage before each use.
Ensure the blade is sharp and the deck is clean. Mow when the grass is dry and avoid cutting more than one-third of the grass height at a time. Consider using a mulching blade for better results.