Toro 5 HP 62924 Operator's Manual
![Toro 5 HP 62924 Vacuum manual cover](/images/XOwVJRQEHLoydEZYvTZMkHbb/thumbs/thumb175x175.webp)
To start the Toro 5 HP 62924 Vacuum, first ensure the fuel tank is filled and the oil level is adequate. Then, set the choke to the "start" position, engage the throttle, and pull the starter cord firmly.
If the vacuum is not picking up debris, check the bag for fullness and replace it if necessary. Also, inspect the nozzle and housing for blockages and clean them if needed.
It is recommended to change the oil after the first 5 hours of use and then every 25 hours of operation or at the start of each season.
Use unleaded gasoline with an octane rating of 87 or higher. Avoid using gasoline with more than 10% ethanol content.
If the engine won't start, check the fuel level and quality, ensure the spark plug is clean and properly gapped, and verify the air filter is clean.
Inspect the air filter before each use and clean it every 25 hours of operation or replace it if it is damaged or excessively dirty.
Unusual vibrations may be caused by loose parts or debris buildup. Check and tighten any loose screws or bolts and clear any debris from the impeller and housing.
Before storing, drain the fuel tank, run the engine until it stops, and change the oil. Clean the unit thoroughly and store it in a dry place.
To replace the spark plug, disconnect the spark plug wire, remove the old spark plug using a socket wrench, and install a new, properly gapped spark plug. Reattach the spark plug wire.
Excessive smoke may indicate an oil overflow or burning. Check the oil level and ensure it is not overfilled. If the problem persists, consult a service professional.