Shark Navigator ZU60 Owner's Guide
![Shark Navigator ZU60 Vacuum manual cover](/images/SJgZzKIzwUghFEVDHeYkbbPF/thumbs/thumb175x175.webp)
To assemble your Shark Navigator ZU60, simply attach the handle to the top of the vacuum body until it clicks into place. Then, connect the hose and attach the desired cleaning accessory.
If your Shark Navigator ZU60 loses suction, check for blockages in the hose or filters. Clean or replace the filters if necessary, and ensure the dust cup is empty.
It is recommended to clean the pre-motor foam and felt filters every three months and the HEPA filter once a year for optimal performance.
Yes, the Shark Navigator ZU60 is suitable for hardwood floors. Use the brush roll shutoff feature to prevent scratching and ensure effective cleaning.
Regularly check the brush roll for tangled hair or debris. Use scissors to carefully remove any obstructions and ensure the roll spins freely.
If your vacuum overheats, turn it off and unplug it. Check for blockages and clean the filters. Allow the vacuum to cool for at least 45 minutes before resuming use.
To replace the belt, unplug the vacuum, remove the brush roll cover, and take out the brush roll. Slide off the old belt and replace it with a new one, ensuring it is properly aligned before reassembling.
A loud noise may indicate a blockage or a problem with the brush roll. Check for debris in the hose, filters, and brush roll, and remove any obstructions.
To empty the dust cup, detach it from the vacuum body, hold it over a trash bin, press the release button to open the bottom, and empty the contents. Snap the bottom back into place before reattaching.
The Shark Navigator ZU60 typically includes a crevice tool, upholstery tool, and dusting brush. Store these accessories on the onboard accessory holder for easy access.