Scheppach SG7100 5906219903 Instruction Manual
![Scheppach SG7100 5906219903 Generator manual cover](/images/PNqnEWrZDdLuRkpUhscUnYkv/thumbs/thumb175x175.webp)
The recommended oil type for the Scheppach SG7100 generator is SAE 10W-30 for general use. It is important to check the oil level before each use and change it after the first 20 hours of operation.
To start the Scheppach SG7100 generator, first ensure it is on a flat surface. Check the fuel and oil levels. Turn the fuel valve to the "on" position, set the choke to "closed" for a cold start, and then pull the recoil starter gently until resistance is felt, then pull it briskly.
If the Scheppach SG7100 generator won't start, check the fuel level and ensure the fuel valve is open. Verify the oil level and the spark plug connection. If the issue persists, clean or replace the air filter and inspect the spark plug for wear or damage.
Regular maintenance should be performed every 50 hours of operation or annually, whichever comes first. This includes checking and changing the oil, cleaning or replacing the air filter, and inspecting the spark plug and fuel system.
The Scheppach SG7100 generator should not be used in wet conditions to prevent electrical shock or damage to the generator. It should be operated in a dry, well-ventilated area and protected from rain or moisture.
To store the Scheppach SG7100 generator, drain the fuel from the tank and carburetor. Change the oil and clean the generator. Store it in a dry, cool place, and cover it to protect it from dust and debris.
Connect appliances to the Scheppach SG7100 generator using appropriate extension cords rated for the load. Ensure the total load does not exceed the generator's rated capacity. Plug appliances directly into the generator's outlets and avoid overloading.
To reset the circuit breaker on the Scheppach SG7100 generator, first turn off all connected appliances. Locate the circuit breaker switch on the control panel and toggle it to the "off" position, then back to the "on" position.
If the Scheppach SG7100 generator is producing low power output, check if the load exceeds the generator's capacity. Inspect the air filter, fuel filter, and spark plug for any blockages or damage. Ensure the engine speed is set correctly.
To safely shut down the Scheppach SG7100 generator, disconnect all appliances, let the generator run for a few minutes without load to stabilize, then turn the engine switch to "off" and close the fuel valve.