Ram Promaster City 2022 Quick Start Guide
![Ram Promaster City 2022 Van manual cover](/images/XNTExoESTFNEtMjlRSagxoYK/thumbs/thumb175x175.webp)
The recommended maintenance schedule for the Ram ProMaster City 2022 includes regular oil changes every 10,000 miles, tire rotations every 10,000 miles, and brake inspections every 20,000 miles. Check the vehicle’s manual for a more detailed schedule.
To reset the oil change indicator, turn the ignition to the ON position without starting the engine. Press the accelerator pedal slowly three times within 10 seconds. Turn the ignition to the OFF position and then start the engine to ensure the light has been reset.
The Ram ProMaster City 2022 recommends using SAE 0W-20 full synthetic engine oil for optimal performance and efficiency.
To improve fuel efficiency, ensure regular maintenance is performed, keep tires properly inflated, avoid excessive idling, and drive at moderate speeds. Removing unnecessary weight can also help.
If your van won't start, check the battery connections to ensure they are tight and free of corrosion. Verify that the battery is charged. If the vehicle still won't start, it may be necessary to seek professional diagnostic service.
To pair your smartphone, go to the Uconnect system and select 'Phone' > 'Pair a Device'. Ensure your phone's Bluetooth is enabled and select 'Uconnect' from the list of available devices. Follow the prompts to complete the pairing.
The Ram ProMaster City 2022 has a maximum payload capacity of approximately 1,885 pounds, depending on the specific model and configuration.
The Ram ProMaster City 2022 features a sealed transmission system, and checking the fluid level typically requires professional service. Consult your dealer or a certified mechanic for assistance.
The Ram ProMaster City 2022 has a towing capacity of up to 2,000 pounds when properly equipped. It is important to follow all recommended guidelines for towing.
To replace a headlight bulb, open the hood and locate the back of the headlight assembly. Disconnect the power connector, remove the rubber boot, and twist the bulb holder counterclockwise to remove it. Replace the bulb and reassemble in reverse order.