Nissan Frontier Owner's Manual
![Nissan Frontier manual cover](/images/704ec02eaba5f41d5f55d9a2/thumbs/thumb175x175.webp)
For optimal performance, it is recommended to change the oil every 5,000 to 7,500 miles, depending on your driving conditions. Always refer to your owner's manual for the manufacturer's recommendations.
Nissan recommends using Genuine Nissan Matic D (ATF) for automatic transmissions or equivalent. Always check your owner's manual for the specific fluid type for your model year.
To reset the maintenance light, turn the ignition switch to the "ON" position without starting the engine. Press the trip reset button until the maintenance light blinks, then release the button.
The recommended tire pressure is usually around 35 PSI. However, it's best to check the sticker on the driver's door jamb or your owner's manual for the exact specifications for your model.
The check engine light can indicate a variety of issues ranging from a loose gas cap to more serious engine problems. It's advisable to use an OBD-II scanner to read the error code or visit a mechanic for diagnosis.
To improve fuel efficiency, ensure regular maintenance, keep tires properly inflated, reduce excess weight, and drive at steady speeds. Avoid rapid acceleration and hard braking.
If the battery dies, you can jump-start the vehicle using jumper cables and another car. Connect the cables properly and allow the dead battery to charge for a few minutes before attempting to start the engine.
To replace the headlight bulb, open the hood and locate the back of the headlight assembly. Remove the power connector, unclip the old bulb, and install the new bulb by reversing the process.
Common causes of overheating include low coolant levels, a malfunctioning thermostat, a blocked radiator, or a failing water pump. Regularly check the coolant level and inspect cooling system components.
To change the air filter, open the hood and locate the air filter box. Unclip the box, remove the old filter, and insert a new one. Ensure the filter is seated correctly before closing the box.