Maserati GranTurismo MC 2012 Emergency Rescue Guide
![Maserati GranTurismo MC 2012 Grand Tourer manual cover](/images/CkSmHTSImUIoOkMzslolUXhO/thumbs/thumb175x175.webp)
The recommended oil type for the Maserati GranTurismo MC 2012 is SAE 5W-40 synthetic motor oil. It is crucial to use a high-quality oil to ensure optimal engine performance and longevity.
It is generally recommended to change the transmission fluid every 40,000 to 60,000 miles. However, checking the owner's manual for specific guidelines is advisable, as driving conditions can affect this interval.
If the vehicle does not start, check the battery for charge and connections, ensure the fuel level is adequate, inspect the starter motor and ignition system, and look for any blown fuses. If the issue persists, consult a qualified mechanic.
To reset the TPMS, inflate all tires to the recommended pressure, drive the vehicle for a few minutes at a speed above 20 mph, and the system should recalibrate automatically. If it doesn't reset, consult your owner's manual or a professional.
To replace the air filter, locate the air filter housing in the engine bay, remove the clamps or screws, take out the old filter, and insert a new one. Ensure the filter is seated properly before securing the housing.
To pair your phone, enable Bluetooth on your device, navigate to the car's Bluetooth settings on the infotainment system, search for devices, select your phone, and confirm the pairing code on both devices.
The recommended tire pressure for the Maserati GranTurismo MC 2012 is typically 32 psi for front tires and 35 psi for rear tires. Always refer to the placard on the driver's side door for the most accurate information.
To check the coolant level, ensure the engine is cool, locate the coolant reservoir, and verify that the coolant level is between the 'MIN' and 'MAX' marks. If needed, add the appropriate coolant mixture to maintain the level.
If the check engine light illuminates, check for any obvious issues such as a loose fuel cap. If none are found, use an OBD-II scanner to read the error code or take the vehicle to a professional mechanic for diagnosis.
To replace the brake pads, lift the vehicle and remove the wheel. Unbolt the caliper and remove the old pads. Install new pads, ensure they are seated correctly, reattach the caliper, and secure the wheel. Test the brakes before driving.