Kenmore 51339 106.5133 Use and Care Guide
![Kenmore 51339 106.5133 Refrigerator manual cover](/images/vSCgZJFNPOSgnYZWDFzUHVeV/thumbs/thumb175x175.webp)
To change the water filter, locate the filter compartment in the upper right corner of the refrigerator. Turn the old filter counterclockwise to remove it. Insert the new filter and turn it clockwise until it clicks into place. Run water through the dispenser for 2-3 minutes to clear any air or impurities.
First, ensure that the refrigerator is plugged in and the thermostat is set correctly. Check for any obstructions in the air vents inside the fridge. Make sure the door seals are clean and sealing properly. If the problem persists, it may require professional service to check the compressor or refrigerant levels.
Defrosting can be done by turning off the refrigerator and allowing the ice to melt naturally. Remove all food items, place towels around the base to catch water, and leave the doors open. For quicker defrosting, you may use a fan to circulate air inside.
Ice buildup can be caused by warm air entering the freezer due to a faulty door seal. Check the gasket for cracks or gaps. Another cause could be a blocked defrost drain, which should be cleared with warm water.
Unplug the refrigerator and locate the condenser coils, either at the back or underneath. Use a vacuum cleaner with a brush attachment to gently remove dust and debris from the coils. Clean them every 6 months for optimal performance.
Loud noises may be due to the refrigerator not being level, causing vibrations. Adjust the leveling legs to stabilize the unit. Also, check for loose items inside that may rattle, and ensure the fan and compressor are not obstructed.
Locate the temperature control panel inside the refrigerator compartment. Adjust the settings using the dial or digital controls to achieve the desired cooling level. Wait 24 hours for the changes to take effect.
Ensure that the ice maker is turned on and the water supply line is connected and not kinked. Check for any ice blockages in the maker. If the problem continues, the water inlet valve may need inspection or replacement.
Unplug the refrigerator and locate the light cover inside the fridge. Remove the cover and unscrew the old bulb. Replace it with a new bulb of the same type and wattage, then reattach the cover.
Yes, the door swing can be reversed. Consult the user manual for specific instructions on how to relocate the hinges and handle to the opposite side. This process typically requires a screwdriver and the assistance of another person.