JennAir Noir JUCFP242HM Use and Care Guide

To set the temperature, use the control panel located inside the refrigerator. Press the "Refrigerator" button to cycle through temperature settings until you reach the desired level.
Ensure that the vents inside the refrigerator are not blocked. Check if the door seals are clean and intact. If the problem persists, consider resetting the appliance by unplugging it for a few minutes and then plugging it back in.
It is recommended to clean the condenser coils every six months to maintain efficiency. Use a vacuum cleaner or a soft brush to remove dust and debris.
Locate the water filter compartment inside the refrigerator. Turn the filter counterclockwise to remove it. Insert the new filter and turn it clockwise until it locks into place.
Check if the ice maker is turned on and that the water supply is connected. Make sure the freezer temperature is set correctly. If the issue remains, refer to the user manual for further troubleshooting steps.
Yes, the shelves are adjustable. To move a shelf, tilt it up at the front and lift it out. Place it in the desired location and lower it into place.
To activate Sabbath Mode, press and hold the "Refrigerator" and "Freezer" buttons simultaneously for 5 seconds. The display will show "Sabbath Mode" indicating it is active.
The refrigerator is frost-free and does not require manual defrosting. However, if needed, you can unplug the unit and leave the doors open to allow any ice build-up to melt.
To reset the control panel, unplug the refrigerator from the power outlet for about 5 minutes. Plug it back in and the control panel should reset.
Keep the refrigerator and freezer doors closed as much as possible. Ensure the appliance is not placed in direct sunlight or near heat sources. Regularly clean the door seals and condenser coils.